Practical Overview of Multiplex Immunohistochemistry using TSA - Part 2 of 4

The basic procedure for fluorescent mIHC with TSA is as follows:

1. Slide-mounted formalin-fixed paraffin embedded tissue sections are deparaffinized in Xylene and hydrated in successive treatments with ethanol and distilled water.
2. Antigen retrieval, in which the masking of an epitope is reversed, is needed to facilitate epitope-antibody binding, which is accomplished by heat-induced epitope retrieval (HIER). HIER can be performed by heating the slides immersed in retrieval buffer with a steamer, microwave, or other dedicated HIER instruments providing the heat source. The most commonly used HIER buffers are a citrate pH 6.0 or Tris-EDTA pH 9.0. The choice of buffer will depend on the antibody manufacturer’s specifications.
3. After antigen unmasking, sections are incubated with an IHC-validated primary antibody. The optimal concentration of the primary antibody must be determined empirically to ensure a high signal to noise ratio; that is, a strong fluorescence signal intensity and minimal background for each target of interest.
4. Following incubation with primary antibody, sections are washed and incubated with the HRP-conjugated secondary antibody, which is specific to the primary antibody. The HRP enzyme is needed to catalyze the tyramide reaction which leads to fluorophore being covalently deposited onto the tissue. This means the fluorophore will remain on the tissue even if the antibodies are removed.
5. After washing the slides, fluorophore-conjugated tyramide is applied. The choice of fluorophore should be optimized to the primary antibody, taking expression level of the target protein and fluorophore intensity into account. In general, an antibody against a low abundance target should be paired with a high intensity fluorophore. Conversely, an antibody against a high abundance target should be paired with a relatively low intensity fluorophore. This is done in an effort to balance signal intensities of the multiple proteins of interest.
6. Steps two through five are essentially a staining cycle which is repeated for each target of interest. Subsequent HIER steps serve to strip primary/secondary antibodies from sample and to unmask the epitope for the next primary. Each cycle of staining uses a distinct tyramide-fluorphore conjugate. The order in which primary antibodies are applied in the multiplex panel must be carefully designed, however, since signal loss and epitope damage increase with each successive cycle of staining. Once all targets have been probed, the slides can be counterstained with DAPI, mounted, and imaged using an appropriate imaging platform.

Bethyl offers numerous immuno-oncology targets and several multiplexing panels.

Continue reading about Multiplexing with our next blog post, "Benefits of Fluorescent Multiplex Immunohistochemistry using Tyramide Signal Amplification."